The HM 12 is a lightweight, high-performance free-touring binding. The frameless design weighs only 1270g/pr, allows a more natural ski flex for enhanced downhill performance, and features a pivoting pin-tech toe piece for increased elasticity, offering skiers more confident retention and reduced pre-release. TÜV approved.
Specifications:
- Din 5-12
- Toe piece type LowTech HM
- Heel piece type HM
- Brake width < 90 mm or 105 – 120 mm
- Length adjustment 45 mm
Details:
Toe – Cast alloy baseplate and forged steel toe arms with hardened pins
Side Towers – New Side Towers aid step-in entry and reduce chances of pre-release from lateral shock.
Four screw mounting pattern rather than the traditional 5 hole Dynafit pattern
Toe Release Lever – Ratcheting toe release lever should be locked for skinning by pulling up.
Crampon Slots – Reinforced crampon slots in baseplate for ski crampons.
Heel – Alloy pivot post with polymer body and stainless steel heel pins
Integrated AFD (Anti Friction Device) in brake heel pad
Release – Lateral and Vertical release both originate at the heel, and release values are set with separate screws.
Speed Step Climbing Bar – New design climbing bar is super easy to adjust while skinning using a ski pole.
Tour Mode – is accessed for all positions by rotating heel 1/4 turn clockwise. Height adjustment is done by flipping the Speed Step Climbing Bar up or down as needed. On the fly adjustments with a ski pole are simple and precise.
Toe lever should be in locked position for skinning.
Heel should only be rotated in clockwise direction.
Boot Compatibility – Compatible with Tech Boots Only – Tech toe and heel fittings must be installed in your boots in order to use this binding. If in doubt, ask your ski tech.